London Road Setup - a scenario for the Woodhead Line route v 1.0

Install
=======

First obtain and install the route.

This scenario was designed with the "The Woodhead Line" route obtained from the
DLC Steam Store.

This scenario uses only default installed rollingstock, so additional installations
should not be required.

Install:
WL_LondonRd.rwp

with Package Manager. Find it via the tab on the opening page.

------------------------------------------------------------------------------------------------------
Running this scenario: You are moving passenger coaches into and out of
Manchester's London Road Station. As such you should attempt to make
your moves as quickly as possible, without speeding for passing a "red"
signal, without permission. Attempt to maintain the schedule as to not
delay other movements, or get yourself locked behind a "red signal."

IMPORTANT NOTE:

If your moves are far outside the intended timings, you MAY experience a permanent
Stop indication. Consult either the f1 or f4 displays for intended arrival times.

As with any complex scenario - SAVE OFTEN.

--------------------------------------------------------------------------------------------------------
NOTES:

It is intended that you drive this scenario from inside the cab of your
shunter, using view 1 and view shift-2. However in order to see all of
the traffic surrounding your train you may want to re-run the scenario
using the "outside" views.

If you experience "jittering" due to low frame redraw rates, lower your graphics settings
on the main page.

======

Your comments are welcome (actually desired) at jbfried@rochester.rr.com
also:
Freidy at UKtrainsim
JimBF at trainsim.com forums

Version History:
0.5 beta test version
1.0 original posting