This is a Bangor and Aroostook re-paint of the excellent DTM F3 unit. That one without driver.      
Of course you will need the DTM F3 UP DLC first.

Installation
------------
1- Open the zip archive, find the Assets folder, drag it to your Railworks folder. Answer "Yes" to the prompt about merging the Assets folders.
2- Drill down to DTM\F3 UP\RailVehicles\Diesel\F3_Engine_MKT folder.
3- Copy F3_MKT_01.GeoPcDx and F3B_MKT_01.GeoPcDx to your Assets\DTM\F3 UP\RailVehicles\Diesel\F3_Engine_Bangor2 folder.
4- To allow the repaint showing up in the scenario editor and to see the repaint when opening the doors from inside the cab, If you haven't already done this when installing my F3_BAR (with driver):
- Go to the DTM\F3 UP\Railvehicles\Diesel\Cabview folder.
- Copy F3_Cab_MKT_01.GeoPcDx, and paste it at the same location, i.e. make a copy in the DTM\F3 UP\Railvehicles\Diesel\Cabview folder.
- Rename the copy to F3_Cab_Bangor_01.GeoPcDx.
- Open the copy with TS-Tools. Click on Search and Replace, write "mkt" in lowercase in the top window and "Bangor" in the lower one. Then click on Replace All.
- Save it and that's it.

To use in a scenario
--------------------
In the scenario editor, enable content from DTM, F3 UP.
Now you should see the F3-Bangor2 no driver and B units along with other units from the DTM DLC.
Also you get a bonus winter version of the BAR2 Units.

------------------------
I want to thank Chacal for his precious help!

Enjoy,
Touzzz
(jtousign)