Thanks for downloading my Pogwassek Island Rail Road repaints of the excellent GE 44tons switcher from DTM, emblazoned by my beaver logo creation.
This switcher is  destined for the fictional route : the Pogwassek Island Railroad, where lots of railroading activities are spread over two Islands.

There are two engines with unique numbers: #14 and #15.  
For these to operate you will need from DTM, the GE 44 Ton and the GE44Ton-SP Assets to be installed first.
Installation
------------
1- Open the zip archive, find the Assets folder, drag it to your Railworks folder. Answer "Yes" to the prompt about merging the Assets folders.
2- Drill down to DTM\GE44Ton-Pogwassek\RailVehicles\Pogwassek-14\Engine folder.
   N.B. if GE 44 Ton appears as an .AP file, it is best to unpack it, for you to have access to the next 2 following binary files...
3- Copy DTM\GE 44 Ton\RailVehicles\Pennsylvania\Engine\GE 44Ton_Penn.GeoPcDx to your Assets\DTM\GE44Ton-Pogwassek\RailVehicles\Pogwassek-14\Engine, and Pogwassek-15\Engine folders.
4- Copy DTM\GE 44 Ton\RailVehicles\Pennsylvania\CabView\GE 44Ton_Penn_Cab.GeoPcDx to your Assets\DTM\GE44Ton-Pogwassek\RailVehicles\Pogwassek-14 and Pogwassek-15\CabView folders.

To use in a scenario
--------------------
Launch the scenario editor and enable assets from DTM: GE44Ton-Pogwassek, GE 44 Ton and the GE44Ton-SP.
Important, GE 44 Ton is required as well otherwise the GE44Ton-Pogwassek14 or Pogwassek15 will not list in the editor.
After activation, you should see the two GE 44 Ton-Pogwassek Island RR Units, each with or without driver along with other units from the DTM DLC.
------------------------
Thanks to Chacal for uploading and managing the RWA Library.

Enjoy, Bernard  April 2025
(QcRail)