Thanks for downloading my CN repaint of the excellent RS3 from DieselWorkshop.
Of course you will need the DieselWorkshop ALCO RS-3 Series WesternMaryland first.

Installation
------------
1- Open the zip archive, find the Assets folder, drag it to your Railworks folder. Answer "Yes" to the prompt about merging the Assets folders.
2- Now you will notice that there is a new folder in your assets called Buzz456. You need it for the decal on both sides of the engine.
3- Drill down to DieselWorkshop\ALCO RS-3 Series\RailVehicles\Diesel\WesternMaryland\Engine folder.
4- Copy and paste rs3.GeoPcDx to your Assets\DieselWorkshop\ALCO RS-3 Series\RailVehicles\Diesel\CN\Engine folder.
5- Copy and paste the Cabview folder to your Assets\DieselWorkshop\ALCO RS-3 Series\RailVehicles\Diesel\CN folder.

To use in a scenario
--------------------
In the scenario editor, enable content from DieselWorkshop, ALCO RS-3 Series and from Buzz456. By the way you need to tick the asset Buzz456 for each route in the route editor
you want to use in any modes (Quick Drive for instance) otherwise the logos won't show up on this unit.
Now you should see the (DW)ALCO RS-3 CN Unit and the no driver Unit along with other units from the DieselWorkshop DLC.
Now the problem with the logos is resolved, one can see them from inside the cab thank to Buzz456 and a RWA member bnsfsubdivision (Kevin), that's great!!!

------------------------
I want to thank Chacal, Kevin and Buzz456 for their precious help!

Enjoy,
Touzzz
(jtousign)