by Buzz Baxter (buzz456)
This is a F3 UP repaint of the JL Wasatch F7.
You will need the JL Wasatch F7 to use these re-paints. Just run the installer or drill down and put these in the proper folder. Then Copy the GeoPcDx files for both the A and B units and paste then into the F3 UP folder. They will show up along with the WAS default Engine.
Enjoy,
Buzz456 at RWA
Please remember even those this file is free, the author still has rights to the file. Be sure to read the readme that is enclosed for further copyright information and instructions to install the file.
DTG's Required Disclaimer
"IMPORTANT NOTICE. Everything on this site is user generated content designed for use with RailSimulator.com Limited’s train simulation products, including RailWorks 4: Train Simulator 2013, Train Simulator 2014 and Train Simulator 2015. RailSimulator.com Limited does not approve or endorse this user generated content and does not accept any liability or responsibility regarding it.
This user generated content has not been screened or tested by RailSimulator.com Limited. Accordingly, it may adversely affect your use of RailSimulator.com’s products. If you install this user generated content and it infringes the rules regarding user-generated content, RailSimulator.com Limited may choose to discontinue any support for that product which they may otherwise have provided.
The RailWorks EULA sets out in detail how user generated content may be used, which you can review further here: www.railsimulator.com/terms. In particular, this user generated content includes work which remains the intellectual property of RailSimulator.com Limited and which may not be rented, leased, sub-licensed, modified, adapted,copied, reproduced or redistributed without the permission of RailSimulator.com Limited."
We have 3546 guests and no members online
