Hello, Thank you for downloading my TTAX + RCAP Trailer modification. I take no credit for any original content within this pack, All credit belongs to Jonathan Lewis and Milepost Simulations for the Raton pass route/assets and also the many talented creators behind the Rail Community Assets Pack at Railworks America. All i did was rebrand the spines and swap out the trailer loads.

For these to work you MUST Have:

Raton Pass: Trinidad-Raton Route
RCAP V2

INSTALLATION WITHOUT UNPACKING THE .ap FILE:

1. Navigate to "Steam/Common/steamapps/Railworks/Assets/JL/Raton"

2. Place the downloaded "RailVehicles" folder into the Raton folder

3. Open RatonAssets.ap and go to "RailVehicles/Freight/SpineCar/Default" Select all the .geopcdx files, there will be 8 of them
   (cara, carb, carc, trucka, truckb, truckc, truckd, trucke)

4. Copy the 8 geopcdx from the .ap file to the TTAX folder located in "Railworks/Assets/JL/Raton/RailVehicles/Freight/SpineCars"

5. Fire up Train Sim and clear the blueprint cache (Main Menu -> Settings -> Tools -> Clear Cache).

INSTALLATION WITH UNPACKING THE .ap FILE:

1. Navigate to "Steam/Common/steamapps/Railworks/Assets/JL/Raton"

2. Using winrar/7-zip unpack the contents of RatonAssets.ap into the Raton folder

3. Place the downloaded "RailVehicles" folder into the "Raton" folder, if asked to merge hit yes. These will NOT overwrite the original spines from the RP route

4. Open "RailVehicles/Freight/SpineCar/Default" Select all the .geopcdx files, there will be 8 of them
   (cara, carb, carc, trucka, truckb, truckc, truckd, trucke).

5. Copy all 8 .geopcdx files to "RailVehicles/Freight/SpineCar/TTAX"

6. Fire up Train Sim and clear the blueprint cache (Main Menu -> Settings -> Tools -> Clear Cache)

USING THESE IN A SCENARIO:

Before trying to place you must make sure that "Raton" (JL -> Raton) and "NorthAmerica" (RCAP -> NorthAmerica) are enabled in the scenario editor. Enabling just JL->Raton will get the TTAX spine cars to show up, but with no piggyback loads.

All cars will show up as "RP TTAX Spine Car A/B/C xxxx" where "x" is the name of the carrier (see: TTAX_RCAP_1.jpg)

Also included are the original 5 loads that came with Raton Pass route on the TTAX spines. These will show up as "RP TTAX Spine Car A/B/C/ load 1/2/3/4/5 (see: TTAX_RCAP_1.jpg)

These files do NOT overwrite the original route files. So all the included scenarios and any workshop scenarios will use the default spine cars (TOFC reporting mark and generic loads). If you have any questions, concerns or issues feel free to PM me at RWA!

See you down the line!
-Wingnut019