by trev123 » Tue Dec 31, 2024 3:20 am
How to Apply to Other Routes
DISCLAIMER: This advice is given on a no-support basis and assumes some prior
knowledge. We recommend you only attempt this if you are confident in your
knowledge of Train Simulator folder structures.
1) Go to the assets folder for the relevant route and find the folder called
‘TimeOfDay’. If there is no folder called this, find the ‘template’ blueprint for
the route which is usually in a folder called ‘TemplateRoutes’. Open this
blueprint and see where the TimeOfDay blueprints are located and go there.
2) Go to your RailWorks directory and navigate to
Assets\AP\WeatherEP\TimeOfDay.
3) Copy the four .bin files in this folder named after each season and paste them
into the TimeOfDay folder of your chosen route. If the naming convention
differs for the relevant route, re-name accordingly so the new files match the
naming of the old.
Please note that we cannot permit the distribution of these TimeOfDay files. If you
wish to distribute a route, or a patch for a route which uses these files, you must edit
the template blueprint to point to the AP\WeatherEP\TimeOfDay folder and enable
the AP>WeatherEP blueprint set in the route editor.
Intel i5-10600K CPU, Asus TUF GAMING Z490-Plus (Wi-Fi) MB, Graphics Asus RTX 3060 TI 8GB OC TUF gaming card Windows 11 Home 64 bit, 16 GB Corsair Vengeance DDR4 ram, Viewsonic VX2728 LED 1080P FHD Monitor, Samsung 1TB SSD + other conventional drives, Corsair 750W PSU.