Problem with Blackwood Creek Revised

[jalsina]

Not to through another wrench out there, but the buildings from the Bessemer route don't show up for me. I have the original payware version of the Bessemer, do I need the freeware version?

20250226121203_1.jpg

Have you enabled Bessemer asset?

Yes I have.

BLE.jpg

Here i go again. Have these buildings a defined visualization distance enough to be able to see them?

[ZaphodScotsman]

Well, back to the main problem, a discord user suggested trying to open the route in borderless or windowed. I did that, but the only result was TS stopped responding.

[pkz19]

[/quote]Here i go again. Have these buildings a defined visualization distance enough to be able to see them?[/quote]

I don't know what that means, but the buildings show up if I go and put them in myself, they just aren't there when I load the route.

Bldg.jpg

[wacampbell]

Not to throw another wrench out there, but the buildings from the Bessemer route don't show up for me. ...

20250226121203_1.jpg

Try turning up your scenery density setting. See here:

viewtopic.php?f=29&t=23809&p=269425#p269425

[pkz19]

Not to throw another wrench out there, but the buildings from the Bessemer route don't show up for me. ...

20250226121203_1.jpg

Try turning up your scenery density setting. See here:

viewtopic.php?f=29&t=23809&p=269425#p269425

Yes, I have it maxed out.

I tried deleting and re-downloading the route, and I have the same issue, specific only to the BLE asset.

[ZaphodScotsman]

Here i go again. Have these buildings a defined visualization distance enough to be able to see them?[/quote]

I don't know what that means, but the buildings show up if I go and put them in myself, they just aren't there when I load the route.

Bldg.jpg

[/quote]

Try turning up the density to 10

In regards to the main problem, the route failing to load, I hope a solution to this is made soon: it may need to be remade from scratch.