Searchlight simulations SD70ACe sound issue

[biddydog9000]

I’m having an issue with the 16n 710G3C-II so what happe is that I put the engine in a certain notch ( notch 5 for an example ) and then I wait 10 seconds ) but then I lower the notch the rpm stays the same and AMPs lower I’m not using my rail driver and I ticked the engine sounds in the editor

[AmericanSteam]

I just did a test run with the UP SD70ACe and all worked normally.

[biddydog9000]

I just did a test run with the UP SD70ACe and all worked normally.

hmm strange

[buzz456]

From your posts a lot of strange things animate from your computer.

[JohnS]

I just did a test run with the UP SD70ACe and all worked normally.

hmm strange

The SD40 sounds do the same thing for me as do others. To me the sensitivity is sometimes not low enough meaning you can't hold the key long enough for the script to react to the change. I've tried several things and communicated with Searchlight on the issues but I just can't get it to work correctly. Also, mentioned in other threads when you try to run from a save it doesn't give the scripts enough time to load properly. One suggestion was to stop the train switch cabs if possible for a few seconds then switch back to reload the scripts.

[Claude350]

And I thought it was just me having these problems.

[jalsina]

I’m having an issue with the 16n 710G3C-II so what happe is that I put the engine in a certain notch ( notch 5 for an example ) and then I wait 10 seconds ) but then I lower the notch the rpm stays the same and AMPs lower I’m not using my rail driver and I ticked the engine sounds in the editor

If I were you I would be sure to download the latest version of the enhancement and install it again.