How to fix this?

Discussion about RailWorks route design.

How to fix this?

Unread postby Shortliner » Mon May 30, 2011 11:20 pm

So I was changing the speed limit on my route (too many tight turns, decided to lower it), and I came across this problem twice in my route. Does anyone know how to fix it? The right hand fly out is completely blank, I can't change the speed limit on this little section of track.

Image
Shortliner
 
Posts: 646
Joined: Thu Aug 06, 2009 9:44 pm

Re: How to fix this?

Unread postby micaelcorleone » Tue May 31, 2011 7:37 am

It seems that you've used different trackrules. This will happen then.

You can try to find out where the exact changepiont is (very hard) or you delete hte whole section and insert new tracks. *!sad!*
User avatar
micaelcorleone
 
Posts: 1668
Joined: Tue Oct 05, 2010 11:04 am
Location: Bavaria, Germany

Re: How to fix this?

Unread postby Shortliner » Tue May 31, 2011 11:50 am

micaelcorleone wrote:It seems that you've used different trackrules. This will happen then.

You can try to find out where the exact changepiont is (very hard) or you delete hte whole section and insert new tracks. *!sad!*


I actually found the exact changepoint, and laying down a whole new section of track is out of the question as this route has very few 0% grades.
Shortliner
 
Posts: 646
Joined: Thu Aug 06, 2009 9:44 pm


Return to Route Design

Who is online

Users browsing this forum: No registered users and 0 guests