Reskin Not Working

[FoodMonsterGuy]

[highlight=][/highlight]I downloaded the Stone Mountain GP7 by Marleyman and it is not working. It's name in the editor list show sup but when I click to place it nothing(not evening couplers) comes up. I ran the installer and didn't see it in the editor list, manually installed then showe din list but can't place on tracks and then finally I installed the HSC scenario included but got an error(seen below). Any support or ideas?

[FoodMonsterGuy]

Okay after trying something here is waht I got but no horn or bell sounds and lots of missing textures.

[buzz456]

Waht did you do too get it to show up?

[FoodMonsterGuy]

Waht did you do too get it to show up?

Some files from the texture folder in cabview and stuff from the simulation from the default PRR livery by copying it to the reskin.

[trev123]

This is what he did. When I downloaded the reskin and tried it in TS I got the same message as you. I then shut down TS and went and checked out the folders for the correct files and found that the Stone Mountain GP7 simulation folder was empty, so I copied and pasted the simulation files from the default GP7 folder into the Stone Mountain GP7 simulation folder, started up TS and was able to run the Horseshoe Curve free roam scenario with the Stone Mountain GP7.

[FoodMonsterGuy]

I got it working now. What I did was copy textures from the default livery into the reskin(to add some missing texture files) then copied the reskin textures over. The extra I copied were to fix the handrails and windows.