Cimarron-Pacific

[Mickey]

I am trying to reinstall the Cimarron-Pacific v2 Route into TS2014. I seem to have all the files required except for the:"cimpac2-extra-assets.rwp" file. If anyone is willing to share this file I would be most greatfull. Also RWTools tells me that I am missing a "camber" sub directory under "Assets." I do not show that I have ever had this directory during a previous Cim-Pac installation??? Any help/advice would be appreciated. Thanks

[gwgardner]

look here for the extra assets:


http://railworksamerica.com/index.php/d ... collection

[Mickey]

Thank You, gwgardner, for the reply and the download info, but only the cimpac2-route.rwp file is available there, not the cimpac2-extra-assets.rwp file that I need. Any help will be most appreciated. THANKS

[arizonachris]

On that download page, where it says "Cimarron & Pacific Route" click on that down arrow. You'll see 3 asset packs and the extra assets.

[Mickey]

Thanks again for explaining the Download, and I did get this file installed. This time RWTools says I'm only missing 2 ChaddockEngineering files, a "onechair" and a "Bridge track". So why does TS2014 stop working before any of the Scenarios begin? This happens after loading either v2 or 2b using the Packager. Any Ideas ?

[arizonachris]

OK, try what's suggested in this Thread, fourth post down: http://railworksamerica.com/forum/viewt ... =34&t=9915

[Mickey]

Thanks for reminding me about the PONtracks.bin bug. I did bring some of these culprits back in while restoring some files from archives. I removed them, deleted the Cim-Pac Route, and reinstalled v2 tested it, then v2b, and tested it. Both times after waiting on a scenario to load I eventually get a blank black screen. Then when I hit Escape, I'm notified that "ST2014 has stopped working." Odly enough, I do not get the option to save an error file???
Any Ideas are most appreciated.

[buzz456]

Run Bob Lattimer's tutorial on third party routes.