A WIP shot for PapaXpress...

[MadMike1024]

Mike,
I have dl'd your E7-SP-freight, your E7-SP-Daylight, and the E7 ATSF Warbonnet. Extreme thanks for these beauties. I do have a couple of questions that I don't know if it is me or if they are general:
1. Cannot get the horn and bell to work on the ATSF E7a units. The SP's work fine. I have tried aliasing the ATSF unit to the default but I can't make that work either.
2. Is the dual light on/off feature only on the ATSF units? The SP daylight has lower light on all the time, the SP freight lower is always off.
Thanks again for the very sweet models.
Topper

Re: the bell and horn for the ATSF... alias it to the same values that are used for the SP.

Re: The light on/off feature was not available when I released the SP Freight unit, so it's dead... there's a link in the Britkits section that has the updated files to make the dual light setups work. http://railworksamerica.com/forum/viewtopic.php?f=21&t=2041

[Kali]

I suspect the SP daylight one doesn't have a script to drive the light - it appears older than the date we got all that fixed up finally. I suspect the engine script from the ATSF one will work ok, either from here or I believe Mr Cowen's beta script pack which is in a thread in his forum somewhere.

[Hawk]

or I believe Mr Cowen's beta script pack which is in a thread in his forum somewhere.

Is this the thread you're talking about?

viewtopic.php?f=21&t=2322

[Kali]

yes, that one

[Topper1948]

MadMike,
The problem of no horn or bell for the ATSF E7 repaint seems to be caused by incorrect providers in the paths: \S3\HornControl.proxyxml and \S3\Horn.xml need to be edited with paths that start with "Britkits".

[MadMike1024]

MadMike,
The problem of no horn or bell for the ATSF E7 repaint seems to be caused by incorrect providers in the paths: \S3\HornControl.proxyxml and \S3\Horn.xml need to be edited with paths that start with "Britkits".

Herm... sorry, that was an error on my part. I originally had included a special sounds folder with the ATSF, and apparently forgot to include it in the last .rwp file. I'm going to look at the light issues with the other E7s and see If I can put a patch file together for them.