Railworks America

I have the CRH2A (from either TS or Just Trains - not sure) but I noticed that the ATP is not functioning.
If you have or have driven the train you will know what I mean.....

In the ATP screen there is suppose to have a bar that shows distance to the next signal and the speedometer is suppose to have a yellow and white color depending on distance to the next speed change. Also the should be a signal aspect showing the color (i.e. yellow, green, red)

At the bottom of the screen there are three buttons that you can push to set the control mode. I believe I am not in full control mode where my issue is.

It tried all buttons and none of them gets me to control mode.

If you know how to get the control mode to FULL...I would appreciate some insight.

Dont know if this is what you need :- Page 15 of the maual.

Yes I have read that....but it doesn't say how to turn on the full control mode.
I assumed it starts that way (from cold start) or it is already on from a hot start (which is the scenario I am in),

But I get no signal on the screen....an no signal no matter what button I push as per the manual.