How to reset after hit " EMERGENCY BRAKES " in simulator

[cnbalasub]

I am NOT sure which key command to reset after I hit the " stop sign " on HUD to get the train stop. I wasn't sure which key to reset and all I did is to turn off and on " Engine Start " on the key above from " stop sign " on HUD and nothing move yet.

Thank you,

John

[trev123]

Try this John it may work. Close the throttle, put the reverser into neutral and apply the brakes to full and then release them.

[buzz456]

I think at least with some locomotives using Trevs method you may also need to wait for the loco to come to a full stop if it's not already there.

[trev123]

I forgot that bit.