Page 1 of 1
How to reset after hit " EMERGENCY BRAKES " in simulator
Posted:
Sat Feb 15, 2020 12:27 pmby cnbalasub
I am NOT sure which key command to reset after I hit the " stop sign " on HUD to get the train stop. I wasn't sure which key to reset and all I did is to turn off and on " Engine Start " on the key above from " stop sign " on HUD and nothing move yet.
Thank you,
John
Re: How to reset after hit " EMERGENCY BRAKES " in simulator
Posted:
Sat Feb 15, 2020 3:53 pmby trev123
Try this John it may work. Close the throttle, put the reverser into neutral and apply the brakes to full and then release them.
Re: How to reset after hit " EMERGENCY BRAKES " in simulator
Posted:
Sat Feb 15, 2020 5:57 pmby buzz456
I think at least with some locomotives using Trevs method you may also need to wait for the loco to come to a full stop if it's not already there.
Re: How to reset after hit " EMERGENCY BRAKES " in simulator
Posted:
Sat Feb 15, 2020 9:40 pmby trev123
I forgot that bit.
