Railworks America

I've been working on a couple of new scenarios for HSC lately. In this route, the signals show up clearly on the 2D map while editing. Or at least they did so until I verified the game cache on my computer yesterday. Now the signals are no longer visible in 2D. I've never run into this situation before and am hoping that someone can tell me how to make them visible again. Let me just mention that I looked at the 2D view's properties fly-out and everything is checked.

Thanks,

Tom Pallen

Same here, but only with HSC. My HSC route was unlocked past week but today was locked which means any update has happened without my knowledgement.

I also noticed that the bottom part of the 2D fly-out is missing, I guess the box to check/uncheck signals is usually placed in this (currently) missing bottom part of pannel. Maybe this explains the "something bad happening" with signals...

Cheers,
Lisboa.

After starting this thread, I initiated yet another cache verification, which turned up 40 some odd files to be reloaded. After that finally ended, I discovered that the signals were showing again in the 2D map. Go figure!

Tom Pallen

I won't go figure, nor verify cache... I have a lot of WIP and will let the HSC as is...