Railworks America

Route Marker button on Navigation Panel - Clicking on this icon opens a set of user-defined button flags, or route markers, in the Properties panel. Use a route marker for quickly moving to certain parts of the route. To jump to a route marker location, select
one of the flags and click on the white arrow button.

However when I use this I arrive at the destination route marker, a long way underground.

Anyone have a tip?

Before you make the jump make sure you Increase you vertical height first.

John

Thanks John,

But from any point in the editor how do I set my current elevation?

glenn52 wrote:Thanks John,

But from any point in the editor how do I set my current elevation?

Not sure if there is a way other than with the camera controls ( ctrl + Up or Down arrow )

John

Capt_Scarlet wrote:Not sure if there is a way other than with the camera controls ( ctrl + Up or Down arrow )John

Thanks again John,
That is the method I was using when I arrived at the destination marker.
But in some situations, the distance from where I found myself underground to 'the surface', meant I may well have traveled faster moving the camera(8) to my destination.
And, that method does not ensure I can nominate the correct elevation of the destination marker...
Track level to track level would have been great but maybe that is not provided for...

If you add the shift key into the mix it will speed up the movement.

John

Capt_Scarlet wrote:If you add the shift key into the mix it will speed up the movement. John

That was already included above....

Before jumping a fair distance, exit editing mode first. Jumping while in normal model will keep you planted closer to Earth.