how to set origins in GN Butte Division

[william11857]

Hello fellow simmers I was wondering how can I make new scenario's for the GN Butte Division Great Falls when I go to make new scenario there is no route origins or starting points is there a way to fix this to add origins to the route. I hope I'm not asking a stupid question.

Thank You
william11857

[artimrj]

Not simple but a bit complicated. A GPS Marker file has to be made for each locaation you would like to show up in the list. This can be done easier with RW Tools.

[OldProf]

You really do not need any preset markers. The method I've almost always used to begin making a new scenario is as follows:
1) In the editor, open an existing scenario of any type for editing.

2) Using the 2D map, find the place where you want your scenario to begin and move to that spot.

3) Place the type of scenario marker you want to use and start work. You can leave the scenario marker's properties box unchanged until later.

[artimrj]

Or you can do it like Tom says.

[OldProf]

Or you can do it like Tom says.