New York Division - Bergen Line Not Driveable

[mikeadams2k]

Has anyone else experienced this? I have the required Add-ons, but the 'Drive' button is not active.
[img]NYD-Bergen2.jpg[/img]

[Overshoe]

Has anyone else experienced this? I have the required Add-ons, but the 'Drive' button is not active.

You can't drive it from the workshop menu. Go to the quick drive menu. Select a consist and then select the route with BOTH a start and destination.

[mikeadams2k]

I had subscribed to the route just a couple of weeks ago, but never ran it. I thought I had seen the route listed, but couldn't remember if it was Quick Drive, or one of the other options. The route doesn't show up in Quick Drive, unless a consist is selected. (for me, at least). Anyway, problem solved, Thank you very much! (I apologize for posting here. Due to the ignorance of an old man, I assumed this was a TS2019 problem.)

[minerman146]

Overshoe- thanks for helping out the new guy! And Mike, welcome. If you have any questions or comments do hop over to my thread on the WIP page here on RWA.

[trev123]

It is only a route not a scenario. Someone would have to make scenarios for it. There may be some already on Workshop.