New York Division - Bergen Line Not Driveable
Posted:
Sat Oct 13, 2018 8:31 amby mikeadams2k
Has anyone else experienced this? I have the required Add-ons, but the 'Drive' button is not active.
[img]NYD-Bergen2.jpg[/img]
Re: New York Division - Bergen Line Not Driveable
Posted:
Sat Oct 13, 2018 8:50 amby Overshoe
mikeadams2k wrote:Has anyone else experienced this? I have the required Add-ons, but the 'Drive' button is not active.
You can't drive it from the workshop menu. Go to the quick drive menu. Select a consist and then select the route with BOTH a start and destination.
Re: New York Division - Bergen Line Not Driveable
Posted:
Sat Oct 13, 2018 9:16 amby mikeadams2k
I had subscribed to the route just a couple of weeks ago, but never ran it. I thought I had seen the route listed, but couldn't remember if it was Quick Drive, or one of the other options. The route doesn't show up in Quick Drive, unless a consist is selected. (for me, at least). Anyway, problem solved, Thank you very much! (I apologize for posting here. Due to the ignorance of an old man, I assumed this was a TS2019 problem.)
Re: New York Division - Bergen Line Not Driveable
Posted:
Sat Oct 13, 2018 12:31 pmby minerman146
Overshoe- thanks for helping out the new guy! And Mike, welcome. If you have any questions or comments do hop over to my thread on the WIP page here on RWA.
Re: New York Division - Bergen Line Not Driveable
Posted:
Wed Oct 17, 2018 8:41 pmby trev123
It is only a route not a scenario. Someone would have to make scenarios for it. There may be some already on Workshop.