Page 1 of 1
Moving a third rail after it has been laid down
Posted:
Sun Aug 18, 2013 12:17 pmby robbit
Is there a way to change the offset amount of a third rail after it has been laid down? The offset that was used was like 5.0 but I need to change it on the whole route to 1.1. Is there an easier way then removing it all and redoing it?
Re: Moving a third rail after it has been laid down
Posted:
Sun Aug 18, 2013 5:03 pmby Bananarama
I'm afraid you'll need to relay the sections.
Re: Moving a third rail after it has been laid down
Posted:
Sun Aug 18, 2013 5:06 pmby robbit
That is a bummer but I will not tackle that job then I was going to try to fix the third rail section of the berlin to wittenberg route. Thanks for the info