Railworks America

I am in the early stages of preparation for the construction of a "highly-accurate" route, The Colorado and Southerns' Clear Creek line, from Denver to Silver Plume, a total of about 55 rail miles. The time frame would be 1920-1939. This would require dual-gauge rail between Denver and Golden. I have seen one picture of someone playing with it in railworks, but I am wondering how *practical* it would be. Would dual-gauge switching be possible? Does railworks coding recognize track with more than one gauge?

I have all of the historical plans, documents, locomotive prints on hand, I just do not have the ability to transfer this into railworks (yet).


Example of the scenery:

Currently it is not possible. What you were seeing was someone laying standard and narrow gauge rail on top of each other (looks fine until you hit a turnout).