Page 1 of 1
Invisible loading points
Posted:
Wed Feb 13, 2013 2:13 pmby BNSFdude
Hi, I downloaded the invisible loading points off TS.com but I can't seem to get them to load my coal hoppers at all. Could any one be of assistance? It would be for the Modern coal silo that was released by EMDSD90MAC.
Re: Invisible loading points
Posted:
Wed Feb 13, 2013 3:36 pmby 1225fan5358
I think the invisible points was made BEFORE the modern silo, so it may not be capable of it.
Re: Invisible loading points
Posted:
Wed Feb 13, 2013 3:39 pmby artimrj
Did you put a siding marker there also? A pick up point (loader/unloader) needs to also have a siding marker. WHen you make the command in the scenario editor you would be picking "loader1@coal siding 1" No siding, no loader.
ALso the invisble ones are hard to place, then they are even harder to find again when you want to move them a little. Try to p[ut them exactly where you want them the first time, or it will be a PITA.
Re: Invisible loading points
Posted:
Wed Feb 13, 2013 5:00 pmby BNSFdude
Okay, Thanks for the help bob! I'll get a marker down ASAP.