Railworks America

I am making a SR-Bridge and it is an Interstate bridge. I selected the one I wish to use and start out a very long bridge. The problem is I keep getting bridge ends in the middle of the bridge. This happens where the red triangles are. It is not on all of them but some. My question is what makes them show up and how do I get rid of them?

IIRC, lofts in RailWorks are limited to 500m, which causes loft items (roads, track, etc.) to place end geometry (if present) in the middle where they're not needed/wanted. I have the same issue when creating long sections of bridge track with gantry end pieces, so I believe the best solution (until RS.com address this issue) is to create a new asset for the middle section of the bridge (regular bridge with ends on either end of the loft, and a non-end section for the long part of the bridge). I'll start working on a set.

Thanks Hack. Just another bump to get over. We are making great progress with RW.

Cant you just delete the ground geometry? if you could edit the file? im a i can poly model but im unclear about the in between steps .