UKTrainSim Ground Textures - How do you Install?

[osonegro]

I got the freeware pack of ground textures from UKTrainSim, ran their nice little installer, in the railworks 3 editor I checked the boxes under UKTS_FP, Terrain_Textures, but I still can not get the textures to show up. I've read here about having to edit the blueprint so that it points to the new textures and I did, I used the railworks blueprint editor and edited the route blueprint, setting provider as KUTS_FP, product to Terrain_Textures, and finally the path to the file as TextureSets\Complete_v1.xml and then tried to load my route, still no new textures. Is there really a way to do this??

[hertsbob]

setting provider as KUTS_FP

Hi

Did you set it to that, or UKTS_FP?

Cheers

Bob

[osonegro]

setting provider as KUTS_FP

Hi

Did you set it to that, or UKTS_FP?

Cheers

Bob

Just a typo... ys to UKTS_FP

[hertsbob]

Just checking.

From what you've posted it seems that you've got everything entered correctly into the blueprint. On the basis of never overlooking the obvious, did you export the blueprint after you updated it or did you simply save your changes? If the changes haven't been exported then although the blueprint has been changed the route won't know about it...

Good luck!

Bob

[thebigroyboyski]

Just checking.

From what you've posted it seems that you've got everything entered correctly into the blueprint. On the basis of never overlooking the obvious, did you export the blueprint after you updated it or did you simply save your changes? If the changes haven't been exported then although the blueprint has been changed the route won't know about it...

Good luck!

Bob

I didn't export the blueprint on my route and the UKTS textures work fine, strange

[hertsbob]

Hi

In that case I've no idea. Sorry I can't offer any other suggestions.

Cheers

Bob

[thebigroyboyski]

You've got me confused as to why mine works Bob. I just used notepad to edit the blueprint and saved it
Osonegro does your route load and show no textures at all and some missing track? It sounds like there is a folder somewhere in the wrong place. I'll not get to go on my computer for a couple of days but if your still stuck I'll post up my blueprint and you can double check everything against yours. From what you've posted you've set it out the same as mine.
If you do a search over on ukts there is a good installation guide written by the fellas that made it