Scalerail and crossovers

[NDORFN]

Anyone else having this problem when making a crossover between two standard spaced straights of Scalerail? I know one solution is to increase the offset distance but I don't want to do that.

[SCLALINE]

only issue i have is the frogs

[NDORFN]

Yeah that's the one. Not a major but it looks pretty crap.

Scalerail Crossover.jpg

[simer4]

Just cut the track right in the middle of the crossover (on the track that goes between), then weld the track. Problem solved.

[NDORFN]

It worked! I was expecting it to be just another solutionless bug. Cheers Simer

[SMMDigital]

Another way to do it is to cut the mainline just beyond the frog. Doing it that way also helps to isolate the switch for proper signal operation.

[SCLALINE]

good, didnt know that one, i have one problem area

[NDORFN]

Another way to do it is to cut the mainline just beyond the frog. Doing it that way also helps to isolate the switch for proper signal operation.

Good advice. Went around and did that to all my switches and it solved some AI issues.