Railworks America

ReDem 1.04b is now available for download at http://www.zugware.com/site/component/content/article/6-try-redem.

ReDem now correctly reads USGS BIL files in four byte float format.

I stickied this for ya'.

How do you use redem to select a track line.

jpetersjr wrote:How do you use redem to select a track line.

It's a while since I've used it but I think I created a google earth kmz path following the route then you select how far you want the dem either side of the line.
I'm sure I just followed the instructions on the redem site.

I don't have a problem with folks digging up old posts, but in this case your reply is probably a bit redundant and out of date a bit.
As a matter of fact, there so much discussion about ReDem in other threads in this forum, this one should probably be locked.