Railworks America

Has anyone had this happen. All the red triangles have changed to two bumpers.

Cannot do anything with them no welding no adjustments of any kind. Whole route is like this.
This is the second time this has happened again.
Any ideas anyone

Don't know why it happens, but when it does if I close out scenario without saving (ctrl+alt+del) and close the main RW screen and start over it will load correctly. If I don't close the main RW screen then nothing changes. I guess something doesn't get loaded correctly sometimes and just takes the second time. Main thing is to not save the bad scenario.

On the next edit, run RW in window mode. Much easier than doing a three-finger-salute.