tile elevation displacement

[gwgardner]

I'm blithely going along scenicing and suddenly notice that a couple of tiles have shifted up in elevation. A river is now buried, and track is now many feet below ground. Neither the river nor the track shifted height, just the tile they were on. Any ideas how I can correct this? And also, how did I cause this!?

[Toripony]

The only way I know to undo this is to restore the tile from a backup. Last resort is to replace that tile with the original one generated when you loaded the terrain. Of course, that requires re-doing your terrain work (Snap-to-track and other sculpting) for that tile.

Sorry to see it happen to you; it's one of those quirks that perhaps no one will ever know the cause. To everyone building a route, it can never be stressed enough... backup, backup, backup, backup, backup...

[PapaXpress]

I had the same problem. I ended up removing what tracks I had and then restoring the terrain tiles. The damage may not be as bad as you think.

[gwgardner]

Thanks for the replies. Now I just need to figure out how to identify which tile it is. I guess that's going to be in the editor somewhere. I'll look.

[PapaXpress]

You can find the tile number in the lower left hand corner of the screen in the editor.

[gwgardner]

thanks again. Everything restored, and I'm a happy camper indeed. I had a backup from the day before, and don't have to make any changes to the track or the river. Awesome.