As many of you may have seen on here, I have been building routes around Kalamazoo. I have custom route markers along the route that work fine. I recently cloned the route so a friend could make alterations. However I cannot get the route markers to show up in the clone. I tried doing everything the same, and initially the base route (N-Line and Maine Maritime) markers would show up, after I attempted to get my markers to show up, now no markers show in the clone, and the original route has the markers show twice.
Might anyone have any suggestions?
I have my own markers set in my own provider folder, and have them duplicated in the G-Trax>MaineMaritime folder, in attempts to get it to work (and presumably why markers are showing up twice in the original route now).
Thank you.