Railworks America

I am doing a beta test on a route and I have some loft assets not showing up. Most do but a few missing. They are there on the original route. They check OK with RWTools and are assigned in the route xml. I even went to a tile where the darn thing was (GNTX_WoodTrestle02) and it's listed as being there on the tile. At this point I'm completely baffled. Oh and if I add it with the world editor it shows up.

Any ideas?

Could it be a low Level of Detail for those lofts that are not covered by your current Settings detail?

All is full right.

My last idea on that: check if the LoD of the assets is set to zero (or any other value) and change it to 10

jalsina wrote:My last idea on that: check if the LoD of the assets is set to zero (or any other value) and change it to 10

I don't know what that means.

When I was redoing Donner Pass, a couple of times the assets wouldn't show correctly until I cleared the Blueprint Cache after doing some work.
Most of the time that doesn't happen, but in these cases it helped.

Jalsina is referring to the properties flyout when you double click the asset. Make sure the detail level is 10 in the upper right flyout.

Here's what I have. If I try to put a value in there it goes to -1. I assume the NA is where you want me to put 10.

Yes, where the "NA" is.
Apparently you can't set the detail level on that asset.

Ericmopar wrote:Yes, where the "NA" is.
Apparently you can't set the detail level on that asset.

OK thanks back to the drawing board.

buzz456 wrote:

Ericmopar wrote:Yes, where the "NA" is.
Apparently you can't set the detail level on that asset.

OK thanks back to the drawing board.

Sorry I´ve been most of the day busy.
Write 10 instead of N/A

When I type 10 it changes to -1.

buzz456 wrote:When I type 10 it changes to -1.

That is weird. 10 is the max value for LoD. Try 9 then.

I think the N/A is "non applicable"