Railworks America

I would like to swap the switch stands in the default Cajon Pass for the scale rail junctions. I already have the scale rail cajon pass but I have hundreds of scenarios for the default CP and would like to make it look at little nicer.

I tried swapping them out in RW Tools but the stands are too far away from the track. IS there a way to get them closer without having to edit them one by one in the World Editor?

Thanks

You may have to swap all of the track in the original Cajon Pass for all the ScaleRail components to line up properly.

Yes I swapped all the track first to SR ATSF. I then swapped the switch stands but they are too far to the side from the rails.

skaliwag66 wrote:IS there a way to get them closer without having to edit them one by one in the World Editor?

Unfortunately no.

I often seem to spend half my life shuffling point motors and switch stands around.

OK thanks, it was worth the try.