Swapping junctions

[skaliwag66]

I would like to swap the switch stands in the default Cajon Pass for the scale rail junctions. I already have the scale rail cajon pass but I have hundreds of scenarios for the default CP and would like to make it look at little nicer.

I tried swapping them out in RW Tools but the stands are too far away from the track. IS there a way to get them closer without having to edit them one by one in the World Editor?

Thanks

[dfcfu342]

You may have to swap all of the track in the original Cajon Pass for all the ScaleRail components to line up properly.

[skaliwag66]

Yes I swapped all the track first to SR ATSF. I then swapped the switch stands but they are too far to the side from the rails.

[Bananarama]

IS there a way to get them closer without having to edit them one by one in the World Editor?

Unfortunately no.

[hertsbob]

I often seem to spend half my life shuffling point motors and switch stands around.

[skaliwag66]

OK thanks, it was worth the try.