Railworks America

Ok so yesterday I downloaded the Portland Terminal route and though this would be a perfect route for gp-9s. I go download the gp-9 pack and start to edit one of the free roam scenarios on the route only to find out the gp-9s are not on the engine list. Now I'm wondering can you even put any engine on any route?

Welcome to the Forum!

Yes, you can:

In the Scenario Editor, klick the blue box in the middle left flyout, then another window opens to the right side of your screen. There you see the developers as a dropdown list.

Select RSC and then search the GP9 pack and activate it by marking the checkbox, and you´re done!




If any further problems occur after that, close Railworks, start new and clear the blueprint cache:








No comment about my artwork !

Thanks for all the help! I really appreciate it! I'm going to go try that now and see if it works, thanks again

You´re welcome! Just ask if you have any questions, here are a lot of nice people willing to help.

If you go into the route editor instead of the scenario editor and do what was stated above, you will have them available for any scenario on that route.

If you go into the route editor instead of the scenario editor and do what was stated above, you will have them available for any scenario on that route.

Yeas, forgot to mention that! Saves a lot of work!