Player train vibrate so hard??

[cnbalasub]

I was checking to see if I can turn off " vibration " in Options Menu of Train Simulator 2020 but I don't see anything like this with " vibration ". Lately I find not just one route but more than one different routes that the player train vibrate very hard when they go over the crossover or switches. Why is that happening with that?? I was hoping that I can find to turn " vibration " off but there isn't one in the Options Menu. Am I stuck with this to see the player train vibrate very hard in different routes.

John

[buzz456]

Example of a route John?

[cnbalasub]

One example is with Canadian Mountain Pass and when the train vibrate. The train drop to 0 RPM also drop the speed too. Hope you know what I mean about this? Anyway here is the HUD in locomotive console. On the left with

------------------
0.0
50

315 RPM
0.00 Amps
-----------------

Also on the right side of locomotive console

[ the key diagram ]

You will see the key in green above.

Here is what happening with the train hit hard (vibrate) then the Amps show 0.00 and the train is dropping the speed. At the same time I turn the key on to get the train back up running again.

That's what I am talking about when the train hit hard on switch or crossover.

John