Page 1 of 1
Signal Double Slip Switch
Posted:
Wed Jul 22, 2020 10:43 amby railduffer
I have succesfully installed 2 double slip switches in my yard. They work great. I use CSX signals on my route with dwarf signals in the yard. Can anyone show me how to install signals for the double slip switches. I would like to see a diagram, and suggestions on the type of signal to use if different than the dwarfs I am currently using.
Thanks
Re: Signal Double Slip Switch
Posted:
Fri Jul 24, 2020 4:01 pmby kris120
It would be easier if you could show us a map of this yard.
You rarely set the links of a signal only to protect one switch.
Re: Signal Double Slip Switch
Posted:
Tue Jul 28, 2020 10:45 amby railduffer
I am no good at drawing a diagram. May I use an overhead view print screen of my yard? The Print Screen shows buildings I used from assets that were down loaded from other creators (from other Routes and assets that were available from the Railworks America website). I want to make sure, by showing these Print Screen of my yard, I will not be violating rules. I am never going to publish my route. It is for my use and pleasure only.