Railworks America

Has anyone else had a problem with this one? I ran the first two parts and greatly enjoyed them but when I try to run the third, it freezes at the loading screen.
I checked it in RW Tools but no errors were found. Any ideas?

I've run all three parts (default engine: CRS prevented me from using the Consolidation) without problems ... excellent work from Jim, as usual.

OldProf wrote:I've run all three parts (default engine: CRS prevented me from using the Consolidation) without problems ... excellent work from Jim, as usual.

Ermm, what's CRS?

Can't remember s*@$.

buzz456 wrote:Can't remember s*@$.

CRS equals Contsipated Recall Symtpom it occurs at a very early age and worssens as one ages.
This can be witnessed in children of a very early when a Parent asks What did I tell you? and the child
says I dont know and starts to pucker up and cry.

That went south fast! I failed to mention that I was trying to run the Connie version. Anybody run that version successfully?

slick204 wrote:I failed to mention that I was trying to run the Connie version. Anybody run that version successfully?

I haven't completed the scenario yet, but I did a quick check and it seems to load and run OK - Just to confirm, I was running Part 3 with the RWA Consolidation.

I am not sure what could cause you to lock.

buzz456 wrote:Can't remember s*@$.

Thanks, I needed a laugh today. Hadn't realised there was a medical term for it, but I have been a suffered for some time. I hate to think what the 844 is going to do to the condition

Uninstall and re-installation did not cure the problem so, apparently the Connie had a boiler tube failure and the RS-1 had to be brought in to finish the job.

Very good set of scenarios. Highly recommended. Thanks Jim!