Tool to lift all route assets 91.44 meters

[minerman146]

Mike,

I would like to check with you to see if a lift of all route assets, lofts, everything if it is at all possible. My situation is this, I created a route at 0.00 meters then lifted and lowered the terrain using measurements form USGS and Google Earth. This was before I was aware of SRTM. Last night I used rwtools to lift, what its advertised to do, the track, switch stands and signals. I know its a long shot, but it would be hugely beneficial to me so that I could more quickly expand my route another 45 miles (its 44 now) if I could use SRTM. But I need everything to go up exactly 91.44 meters (300 feet).

My route is the New York Division-Bergen Line in the Workshop, I also have a thread here on RWA in the WIP section. I am a registered rwtools user as well.

Regards,
Adam Lambert

[Chacal]

So the route is going to get an uplift?

[mikesimpson]

There is an option in RW_Tools to lift/lower the track, but it is only intended for the track and was only intended to raise/lower it by a few inches, not by 300ft. The idea was to correctly align 3D track where it had been swapped for 2D track.

There is no option to raise every asset by a given amount.

Mike

[minerman146]

There is an option in RW_Tools to lift/lower the track, but it is only intended for the track and was only intended to raise/lower it by a few inches, not by 300ft. The idea was to correctly align 3D track where it had been swapped for 2D track.

There is no option to raise every asset by a given amount.

Mike

Mike thanks for the confirmation that I cannot raise the all assets with the tool. Back to hand formed terrain!
For what its worth, I did execute a 300 foot lift of track, switch stands AND signals with your tool. Impressive!

Regards,

Adam

[mikesimpson]

You could use that for a roller coaster...

Mike