Santa Fe Dash-9 44CW

[ET44C4]

Using DTG's Miami to West Palm Beach CSX Dash-8, you could FINALLY make a Santa Fe Dash-9 44CW. Make three versions if possible. (Clean, Weathered, Patched Weathered)

[BigBoyMoon]

But there already are some ATSF C44-9Ws on here

[AlcoFan]

That's a C40-8W, not a C44-9W.

[buzz456]

To some of us these boxes all look alike.

[ET44C4]

But there already are some ATSF C44-9Ws on here

Using RSC's Dah-9 pack which does not include lower ditch lights.

[ET44C4]

That's a C40-8W, not a C44-9W.

I know but it looks the same. Also can't anyone just say "I can do that repaint"???

[ET44C4]

That's a C40-8W, not a C44-9W.

BTW, that's why I put "Santa Fe Dash-8" at the bottom of the photo.

[AlcoFan]

BTW, that's why I put "Santa Fe Dash-8" at the bottom of the photo.

Fair enough, but the title of the thread says otherwise.

I know but it looks the same. Also can't anyone just say "I can do that repaint"???

You might have better luck if you put out one request at a time, instead of posting 3 within the span of 2 days. No one is obligated to do a repaint for you.

[ET44C4]

BTW, that's why I put "Santa Fe Dash-8" at the bottom of the photo.

Fair enough, but the title of the thread says otherwise.

I know but it looks the same. Also can't anyone just say "I can do that repaint"???

You might have better luck if you put out one request at a time, instead of posting 3 within the span of 2 days. No one is obligated to do a repaint for you.

Okay, sorry about the suggestions too. I will "slow my roll" with them. I just wanted to get this one out so bad!

[RailfanKyle]

That's a C40-8W, not a C44-9W.

I know but it looks the same. Also can't anyone just say "I can do that repaint"???

Not for nothing the Miami to West Palm Beach D8 has low numberboards. Santa Fe used High numberboards.

[Noel]

Dude. Seriously. Just use the ATSF Dash 9 reskins. Begging like you've been doing is not only going to have people DENY your request, but it's also VERY annoying. Get a grip.