Railworks America

Anybody have a blank RS11 template laying around?

I don't remember ever seeing one. The original releases were the Pennsy and a Lehigh Valley version (one via Steam the other direct from vR).

edit: The Steam version was the Pennsy and the Lehigh Valley is still on vR's website.

had to dig to really find this

https://thelocoshop.wixsite.com/theloco ... -downloads

scroll a bit and you'll find the RS-11 textures.

I have one by MDurdan if you still need it.

spartantrain32 wrote:had to dig to really find this

https://thelocoshop.wixsite.com/theloco ... -downloads

scroll a bit and you'll find the RS-11 textures.

Thank you.

...........I like where this is going.

Chugging along on this thing. Lot's of bits and pieces on this model.

One of my preferred engines in the game gets a new dress!

Pretty close to going out for beta.

Anyone have any ideas if it's possible to get this thing to run short hood forward?

buzz456 wrote:Anyone have any ideas if it's possible to get this thing to run short hood forward?

Wouldn't that be something!

buzz456 wrote:Anyone have any ideas if it's possible to get this thing to run short hood forward?

It's been a while / a few years, but I think one of them was set up long hood forward from the vR "factory". Likely the PRR unit.

Both versions currently available are set up for long hood forward, the PRR version (Steam) and the Lehigh Valley version (vR direct).

GreatNortherner wrote:

buzz456 wrote:Anyone have any ideas if it's possible to get this thing to run short hood forward?

It's been a while / a few years, but I think one of them was set up long hood forward from the vR "factory". Likely the PRR unit.

What I need is the cab turned so the short hood forward is correct. I have the loco running short hood forward just haven't puzzled how to get the cab going that way.

buzz456 wrote:What I need is the cab turned so the short hood forward is correct. I have the loco running short hood forward just haven't puzzled how to get the cab going that way.

Ah, got it. Sorry, I misread your earlier post and thought you were looking for a long-hood forward version.

I don't think flipping or moving the cab is doable without changing it directly in the source 3D model. As far as I can remember, there aren't any directional/positional parameters for the cab model in the blueprints (like there are for child objects).

If you're willing to sacrifice the entire functionality and animations of the cab, maybe you can use it as a child object and move it into the desired position there and then delete the actual cab reference from the loco BP.