Railworks America

Horn would be a K5HL, and thanks! I needed a new bell for the ES44!

Sounds awesome!


Now do a K5LLA for the SD70ACe.

Liiiiiink?

Instructions on Install? I followed the readme link and I didn't know what to do.

Thanks very much!!!!.....on a side note, does anybody have the ES44DC engine bin file, i seem to have screwed mine up some time ago and without that the sounds dont work...i would usualy do a verify cache but it would take me over an hour getting all my sounds and stuff back to where i like them...(horn and bell sounds, motor sounds, couplers...etc)

Thanks, but I'm talking about the K5LLA, not the K5LA.

thecanadianrail wrote:Thanks very much!!!!.....on a side note, does anybody have the ES44DC engine bin file, i seem to have screwed mine up some time ago and without that the sounds dont work...i would usualy do a verify cache but it would take me over an hour getting all my sounds and stuff back to where i like them...(horn and bell sounds, motor sounds, couplers...etc)

I've also tried to replace the sounds on that one, messed up too.

thecanadianrail wrote:Thanks very much!!!!.....on a side note, does anybody have the ES44DC engine bin file, i seem to have screwed mine up some time ago and without that the sounds dont work...i would usualy do a verify cache but it would take me over an hour getting all my sounds and stuff back to where i like them...(horn and bell sounds, motor sounds, couplers...etc)

After a verifying you can re-install all your mods with 2-Clickz and 1 minute to go (size of assets and rig dependent). Currently I have over than 250 mods (5GB) installed in 3 minutes in my average (slow) machine. The trick is here:
Reinstall RW3 Mods with 2-Clickz (Basic)
viewtopic.php?f=6&t=5383

Cheers,
Doc.

Thanks b737lvr. I didn't even see it. My brain was mush, I just couldn't think.

Nice job on this one and your others for that matter. Amazing how new horns and bells breath new life into an old model.

Machinist wrote:

thecanadianrail wrote:Thanks very much!!!!.....on a side note, does anybody have the ES44DC engine bin file, i seem to have screwed mine up some time ago and without that the sounds dont work...i would usualy do a verify cache but it would take me over an hour getting all my sounds and stuff back to where i like them...(horn and bell sounds, motor sounds, couplers...etc)

After a verifying you can re-install all your mods with 2-Clickz and 1 minute to go (size of assets and rig dependent). Currently I have over than 250 mods (5GB) installed in 3 minutes in my average (slow) machine. The trick is here:
Reinstall RW3 Mods with 2-Clickz (Basic)
viewtopic.php?f=6&t=5383

Cheers,
Doc.

You must remember out of everybody else here at rwa i have the worst pc rig....single core with less than 4gb ram...and a low end vid card...i technicaly dont meet minimum requirements for railworks but yet it somehow it still runs?

Its so awesome, I will have to make another video just for this release.