Railworks America

A set of 8 scenarios packaged together has been uploaded. Your a local freight going from east to west stopping at a few places to pick up, drop off and load cars.

While we were testing these scenarios several bugs were found on the route. I made a small patch to fix the route.

Get the patch at Patch 1.1a 1.9 meg.

This patch removes some signals at Kerri's Lumber.
Fixes a signal in Moeller Mills yard.
Removes one unloader at Henderson Cement that had two on top of each other.
Fixes a signal at East End Yard on the main that lets AI pass the signal before stopping.

You will need this patch in order to make the JMcE scenarios 001 series work properly.

The loading screen should say version 1.1a now.

Have fun with them.

Unzip and run route_setup.exe as an admin.

They are online now. Also on the patch, had a few people tell me it didnt install correctly, they all have RW on drive c: in the program files structure. So some of you may want to manually copy the files over.

The loading picture: loading_North Eastern - PA Div.TgPcDx dated 3-18-2012 still shows version 1.1a in the picture. I believe that the route has updated because I have the right dates on the files, but you may have failed to update the version in the loading picture.

The patch is Version 1.1a so I'm guessing that the loading screen should also show 1.1a, as mentioned in Bob's first post.

Whwew can I find the ' NE Black SW 1200 dirty'? Have not been able to locate this item for the 'Passenger run".

jamesphh wrote:Whwew can I find the ' NE Black SW 1200 dirty'? Have not been able to locate this item for the 'Passenger run".

In the SW1200 package artimrj-EMD_SW1200_Switcher

Conatins the black one, one for Henderson cement and csx ones.

Thank you. I had already installed this file and the only two that installed were the two CSX units. Re downloaded and reinstalled but 3 folders did not install.
Manually installed missing 3 folders and they now appear on the list if available engines.
Have no idea why these 3 folder will not install with the rwp.
Currently in middle of run for this scenario ( with a substitute SW 1200 engine) and will reinstall scenario when complete and see if all is correct.

Strange stuff there, had no other people say anything about it. I have new virgin install I set up and am going to install only my NERW stuff on it. Maybe the RWP is corrput but not enough to grab it all manually??

Strange indeed! I do not remember any rwp failing. Manual install worked and RW Tools no longer reports the SW as missing. No error on scenario start up.
One other issue.
With the PA Div and with one P&LE beta the GN tele lofts do not connects correctly (poles too high).
Reinstalling the lofts from an original file restores the lofts correctly. Odd again. Some files may be sensetive to corruption. Or perhaps an over write cause issues.
Anyway it is fixed. Enjoyed the senarios that I have run.