Railworks America

Thus far, I have been able to begin building a new route in TS2014.

When I try to create a route using the interface in TS2014 (entering lat/long and choosing a ground texture - Portland Terminal) the game crashes.

When I try to crate the route using the Direct Route set up on RW Tools, I get an error message stating "Permission denied occurred in WriteFile while processing"

Have you tried using a different route template, other than Portland Terminal? I don't have that route, so tried it with HagenSiegen and the Western Route, with no problem.

Also try not entering the origin coordinates, using 0/0, and then select the route template, thus using the coordinates of that route.

In short, try to narrow down what element of the process causes the crash.

If no luck narrowing the cause down, then you should probably 'verify cache' and retry.

Sorry if the above is not all that helpful, but those are the test steps I'd try.

gwgardner wrote:Have you tried using a different route template, other than Portland Terminal? I don't have that route, so tried it with HagenSiegen and the Western Route, with no problem.

Also try not entering the origin coordinates, using 0/0, and then select the route template, thus using the coordinates of that route.

In short, try to narrow down what element of the process causes the crash.

If no luck narrowing the cause down, then you should probably 'verify cache' and retry.

Sorry if the above is not all that helpful, but those are the test steps I'd try.

Well that was it; for some reason you can not (or at least I can not) use Portland Terminal. I was able to create the route using TS2014 but but had to uninstall then reinstall RW Tools to get it to work. Did a verify cache but still no luck on the Portland Term.