Railworks America

When starting a route, in the Editor, it begins at elevation zero and the wrong location. Is there a way to get it back to the proper elevation and location at start-up?

Do you mean you're underground when entering the editor? If so, then you'll need to click on the scenario marker when you first enter the editor, rotate it slightly, hit the "J" key to set it at true ground level (assuming you're using DEM), and then save (F2). However, if you enter the game and then go to editors (Ctrl + E), then point your camera view downward and see if you can spot the marker in the big black void and use the steps above. The first method is much easier though.

Worked--Thanks