Railworks America

Posted: **Mon Jun 03, 2013 7:57 am**

Hi all,
What is the procedure to get non lofted bridges to snap to track on a incline. I used to know but now forget. Thanks.

Posted: **Mon Jun 03, 2013 11:32 am**

Hay,

This might help you:

Hack wrote:You can use the TAB key to align the object to the track. The object needs to be a newly placed object fresh from the objects list - objects already dropped into place will not work:

1) Select an item from the object list
2) Before dropping it into place, hold the TAB key down while hovering the object over a section of tangent track
3) The object should "snap" to align with the track - if it doesn't, adjust your camera view slightly and try again (don't drop the object or release the TAB key)
4) If the object is 90 degrees to the track and pointed the wrong way, go ahead and drop it in place and use the Ctrl key and the object spinner to rotate it into position

Posted: **Sat Jun 15, 2013 7:03 am**

Thanks for the response, and it did work except it doesn't adjust the bridge the length of it on inclined track. That's the real tough part.

Railworks America

How to get bridges to snap to track

How to get bridges to snap to track

Re: How to get bridges to snap to track

Re: How to get bridges to snap to track