Loads Not showing?
Posted: Mon Apr 01, 2013 4:28 pmHi again;
On to a new item. Going through and loading different cars from Portland Terminal Route. In this case the 50FT flatcars. I am getting two of the four loads to show and two do not. The loads are I-Beam and Steel, which do not show up (this is true for both B&M and MEC). Logs and rails do show up. I have gone through to check for file misspellings or folders not pointing to the right file and all looks okay to me.
Portland Terminal was upgraded to TS2013...right.
I am running a high-end system with dual Nvidia 580's and all Railworks options set to high.
Any suggestions on what to check or why this would be happening would be appreciated.
Regards, Gerry
On to a new item. Going through and loading different cars from Portland Terminal Route. In this case the 50FT flatcars. I am getting two of the four loads to show and two do not. The loads are I-Beam and Steel, which do not show up (this is true for both B&M and MEC). Logs and rails do show up. I have gone through to check for file misspellings or folders not pointing to the right file and all looks okay to me.
Portland Terminal was upgraded to TS2013...right.
I am running a high-end system with dual Nvidia 580's and all Railworks options set to high.
Any suggestions on what to check or why this would be happening would be appreciated.
Regards, Gerry