Railworks America

Has anybody been able to get kellnuts sounds to work? I am having trouble with them.

Working on my TS2013...

How did you install them? The same way or a differnet way?

Did you copy and paste one of the volume changes files? I couldn't figure out why they wouldn't work for almost a week until I realized I skipped that step.

dfcfu342 wrote:Did you copy and paste one of the volume changes files? I couldn't figure out why they wouldn't work for almost a week until I realized I skipped that step.

Yes still not working on Sherman Hill

Since SH has its own rail vehicles folder, you have to port all of Krellnuts sounds over there and activate one of the loadness folders.
In default config SH doesn't go outside of its own asset folder, so it doesn't know about any other sounds anywhere else.

I do not understand what you mean (my english is not very good), when you says, "and activate one of the loadness folders".
Can you explain how to do this?

Should have been loudness folder.

Pick one of the four folders in the "Volume Changes" folder. Each folder contains three files with settings so the sounds will play at different volume levels.

Copy one set of the three files to the same folder you copied all the .wav files.

If you wish to change volume levels, pick a different "Volume Changes" set and copy the three files, replacing the previous three files.

GaryG