Page 1 of 1
Portland Terminal
Posted:
Sun Aug 26, 2012 3:33 pmby LandN
Quite a while back I purchased Portland Terminal and ran the default scenarios with no problems. Now when I try to run a scenario, even one of the default ones, the route will not even load. Any suggestions?
Jay
Re: Portland Terminal
Posted:
Sun Aug 26, 2012 3:42 pmby Chacal
Maybe you never got the update. Verify local cache.
Otherwise, I would try deleting saved scenarios.
Re: Portland Terminal
Posted:
Sun Aug 26, 2012 8:14 pmby arizonachris
AFAIK, Rick is still working on the upgrade to TS2012. I ran it earlier today, it runs just fine. And, yes, verify local files, clear blueprint cache.
Re: Portland Terminal
Posted:
Tue Aug 28, 2012 6:58 pmby LandN
I have verified cache a couple of times so I don't think that is the problem. I have deleted all scenarios except for the default ones. If it runs then, I will start to add them back one at a time.
Jay
Re: Portland Terminal
Posted:
Fri Aug 31, 2012 11:55 amby LandN
Deleted all references to Portland Terminal and then verifyed cache. Tried to run the initial scenario but route still wouldn't load. Has to be somewhere in the default scenarios(I guess).
Jay