Portland Terminal

[LandN]

Quite a while back I purchased Portland Terminal and ran the default scenarios with no problems. Now when I try to run a scenario, even one of the default ones, the route will not even load. Any suggestions?

Jay

[Chacal]

Maybe you never got the update. Verify local cache.
Otherwise, I would try deleting saved scenarios.

[arizonachris]

AFAIK, Rick is still working on the upgrade to TS2012. I ran it earlier today, it runs just fine. And, yes, verify local files, clear blueprint cache.

[LandN]

I have verified cache a couple of times so I don't think that is the problem. I have deleted all scenarios except for the default ones. If it runs then, I will start to add them back one at a time.

Jay

[LandN]

Deleted all references to Portland Terminal and then verifyed cache. Tried to run the initial scenario but route still wouldn't load. Has to be somewhere in the default scenarios(I guess).

Jay